SAM MONOLITHICS Pvt. Ltd.
Home Sitemap
Home About Us Products Sister Concern Feedback Contact Us
MANUFACTURING  PRODUCT RANGE: SAM REFRACTORIES   PRODUCTS
Nozzle Filling Compound
Basic Ramming Mass
Acidic Ramming Mass
Laddle Ramming Mass
Back Fill Mass
Patching Mass
SR Cast 60
SR Cast 90
Coil Coat
 
  Monolithic Formulations For Induction Furnace:
 
Products Mg0% SiO2% Cr203% Grading
mm
sintering
TempOCMin
Application
TempOCMax
AApplication
Area
Ind Ram C 72 6.9 10.5 0-4/0-5 800 1750 For making S.S. and for interrupted operations
Ind Ram M 88 6.9 - 0-4/0-5 800 1750 Manganese steel and for continuous process
Mag Top 72 7 10 0-4 800 1750 For making top of Furnace above coil.
Patching Mass 72 7.5 10 0-0.5 800 1750 For patching and Filling cracks.
Coil Coat 86 7.5 - 0-0.25 - - Protective coil coating for H.F. Induction furnace
Silica Ramming Mass - 98.2 - 0-5 800 1750 For Melting Cast Iron, S.G.Iron
 
Product Manufacturing:
 
Products MgO% Min. SiO2% Max. Sintering Temp 0C Grading MM Application Temp0C Application Area
Lad Ram 48 38 --- 0-4 1700 For Lining Small Ladles unto 1000Kg.
Back Fill Mass 47 38 --- 0-4 1700 For Back Filling Of AOD Lining.
 
Product Manufacturing:
Ind Ram C: Induction Furnace Ramming Mass made from Dead Burnt Magnesite in association with Chrome and other Chemical Binders.
Patching Mass: Material is designed for repairing the cracks and erosion that occurs in lining during usage.
Coil Coat: Special mix manufactured from dead burnt magnesite powder with high purity additives to protect coils of the induction furnace. Use as insulation to coil in high/medium frequency induction furnaces.
Silica Ramming Mass: Induction Furnace Ramming Mass made from Silica Material with high purity additives.
Lad Ram: This Magnesite base Laddle ramming mass with high refractory ness and having very good strength. Being a dense material and having high thermal conductivity it takes less preheating time thus saving precious fuel/time. Ladle/Hand Shank lined with Lad Ram gives much more life than ordinary material.
Back Fill Mass: Magnesia-Based dry refractory mixes designed for use as back fill behind AOD vessel walls and bottoms. When used as a parting layer between working and safety lining brick, Back fill mass resists metal penetration, protecting the safety lining, and makes tear out of the working lining easier.
Nozzle Filling Compound: This Material used for filling in the well of the slide gate well Block. Various Grades of Nozzle filling made depending upon types of steel manufactured and holding time of ladle and the temperature of the melt..
 
 
s
 
 All rights Reserved by : SAM Monolithics Pvt. Ltd.   Disclaimer | Privacy Policy | Terms and Conditions
Design and Developed by : WWIS